Acquisitions X-FIRE 1200 User's Guide

X-FIRE 1200This appliance is suitable for use on Natural gas (G20) at asupply pressure of 20 mbar or Propane (G31) at a supplypressure of 37 mbarUSER

ClearancesX-FIRE 1200 Mantle ClearancesIf any part of the installation (mantle, wallor cavity) is constructed frommaterials, the diagrambelow shows th

Removing the Glass AssemblyX-FIRE 1200Ensure the X-FIRE 1200 is allowed to cool before continuing with the followingprocedure.Pull the four hooks show

Follow the instructions on page 8 in reverse to refit the glass assembly tothe fireplace.Cleaning and Maintenance9Fuel Bed MediaSome discolouration of

Note: Each time the fire is lit from cold the glass will fog up with condensation.This is normal and the condensation will disappear within a few minu

WARRANTY TERMS & CONDITIONS:This warranty does not affect your statutory rights.Provided that the Product is installed as stated in the Installati

2. If the buyer or any other party modifies any part of the Product within the LimitedWarranty period without the prior written consent of Ac

DO NOT PLACEARTICLES OR FURNISHINGS ON ORAGAINST THISAPPLIANCE.DO NOT OPERATE THE FIRE IF THE GLASS HAS BEEN BROKEN, DAMAGED OR IT ISNOT PROPERLY POSI

Basic OperationTurning the X-FIRE 1200 onSetting the Control ModeLocking the Remote ControlContents>125Operation from the touch pad5Cleaning and Ma

Basic OperationThe X-FIRE 1200 remote control allows you to turn ON and OFF the fire,control the flame height in the Manual mode, or control the room

Basic Operation2To turn off the fire, push the OFF button, to shut down the gas flow to the fireand switch it off. The OFF display will now appear in

Basic Operation3X-FIRE 1200If Auto is pressed in the initial screen, 25ºC (77 º F)appears as the desired temperature in the selectedsetting. In the bo

Basic Operation4The daily program screen consists of:A: Selected (including “Daily”). The selectedday can be changed by pressing Change(middle button)

Basic Operation5Operation from the Touch PadThe touch pad is intended to be used for service/diagnostic purposes and tooperate the fire in the event t

ClearancesCabinet ClearancesThere must be a minimum of 100mm from the sides of the fascia to anyprotruding side walls or cabinetry.Television Position